1951 dodge engine Id

Mark
Mark
in The Flathead Forum
How do I find out what is the cid of this engine

Comments

  • Mark
    Mark
    engine is not original 25 inches long
  • LHudson
    LHudson
    The long blocks were either 251 or 265 cu in. . The p15-d24 board is devoted to mopar. Lots of info. over there. Hope this helps.  LHud
  • Lance
    Lance
    Mark, Not sure you're at the right place. You're looking for the engine  ID to a 51 Dodge?   OK well this is the Hudson forum. Likely not going to be of much help. Maybe the Mopar forum might be better for you. If you still think you have a Hudson engine then take a picture of it and post it. 
  • Jon B
    Jon B
    The Flathead Forum is a left-over from the days when this was the Classiccar Forum, and had categories for many different marques.  So I think it's not unusual that we'd have someone occasionally posting about a Ford, Dodge, or whatever, under this particular category.
  • Mickel1992
    Mickel1992
    edited August 2017
    kizi Not sure about it 



This discussion has been closed.

Categories

In this Discussion