Clutch disc diameter 52 Hornet

dave11
dave11 Expert Adviser
A number of years back I purchased a clutch disc (cork) at a swap meet, apparently it is for a Hornet.
How would I identify it, thinking of size and number of splines etc?

Dave Eddie

Comments

  • It should be 10" in diameter.  Ten inches was for all Stepdowns 1948-1954 except the Pacemaker (and maybe the 53-54 Wasp) with a non-overdrive, non-Drivemaster 3spd manual (9" diameter). 

    I believe the spline count is the same on both, but I could be wrong.
  • dave11
    dave11 Expert Adviser
    Tks mine is a 10” dia, maybe it was a good find !
  • Here is a nice picture of ready versus worn for the Hudson 10" clutch.