212 Crankshaft pulley Bolt
longlivelance
Member
in HUDSON
I'm looking for a crankshaft bolt for a 212 engine. I read in the forums that it was a 3/4-16 UNF with a 1-1/2" hex head. I was searching online to try and locate one, but did not find anything. I've attached a photo highlighting the bolt 'm looking for.
Does anyone know where I could find one?
Does anyone know where I could find one?
0
Comments
-
Will need a good clean-up on the crank pulley - probably a bottom tap. Didn't Hudson use same bolt for many years ? Get a used one (from Lance?).0
-
Thanks for the lead. I did find Lance's website and sent a message about the bolt. 100% going to need a clean up on the crank pulley. Just getting going on the truck and was trying to see if the engine was seized when I discovered the missing bolt.0
-
Don’t try to turn the engine from the crank bolt when you get one. Try to turn it from the flywheel.0
-
Lance -check your email.0
Categories
- 36.6K All Categories
- 84 Hudson 1916 - 1929
- 18 Upcoming Events
- 73 Essex Super 6
- 28.3K HUDSON
- 507 "How To" - Skills, mechanical and other wise
- 989 Street Rods
- 150 American Motors
- 170 The Flathead Forum
- 47 Manuals, etc,.
- 68 Hudson 8
- 40 FORUM - Instructions and Tips on using the forum
- 2.7K CLASSIFIEDS
- 592 Vehicles
- 2.1K Parts & Pieces
- 76 Literature & Memorabilia
- Hudson 1916 - 1929 Yahoo Groups Archived Photos