Throttle rod to carburetor retainers

JasonNC
JasonNC Expert Adviser
The rods that connect to the carburetors on my Twin H setup just simply go into the holes on the throttle adjuster cam without any visible means to hold them in place.  Well, on the front rod, it looks like an really small "c" or "e" clamp may fit in the tiny slot at the end of the rod, but there is nothing on either that fits the bill.  Is there supposed to be a hole in the end of the rod where a cotter pin could be used to hold it in place or what?  As it now stands, the only thing keeping these rods attached to the carburetors is the tension from the spring that goes from the rods to the base of the carbs.  

Comments