Official HET Club Web Site
HET Club Facebook Page
HET Historical Society
It looks like you're new here. If you want to get involved, click one of these buttons!
Hudson 1916 - 1929
Essex Super 6
"How To" - Skills, mechanical and other wise
The Flathead Forum
FORUM - Instructions and Tips on using the forum
Parts & Pieces
Literature & Memorabilia
Hudson 1916 - 1929 Yahoo Groups Archived Photos
In this Discussion
Clutch disc diameter 52 Hornet
A number of years back I purchased a clutch disc (cork) at a swap meet, apparently it is for a Hornet.
How would I identify it, thinking of size and number of splines etc?
It should be 10" in diameter. Ten inches was for all Stepdowns 1948-1954 except the Pacemaker (and maybe the 53-54 Wasp) with a non-overdrive, non-Drivemaster 3spd manual (9" diameter).
I believe the spline count is the same on both, but I could be wrong.
Tks mine is a 10” dia, maybe it was a good find !
Here is a nice picture of ready versus worn for the Hudson 10" clutch.
Forum Software Powered by Vanilla