eshelman molding
2manyprojects
Expert Adviser
in HUDSON
in jan. i contacted gregg and asked if i could send a couple of 38 hudson country club dash knobs to him so he could make some new ones for me.he agreed and i sent them. weeks passed no word from gregg so i sent him a note he stated he has not gotten to them. two more months go bye no word still. so i contact him and get no reply. i wait a few more weeks and try again. he replys he does not want to do them and sends them back. a total of 6 months wasted with gregg it appears that he does not do business like his father did. i talked to a club member from n.y. state at the eastern regional and he had the same bad experience with gregg. just letting people know what has happened to us.
0
Comments
-
Time to get someone to 3D print them.0
-
anyone know who does 3d print0
-
Grim Greaser a member here and uses a commercial 3D printing house to make his designs... check with him for contact information.0
-
On the other hand I've always had pleasant dealings with Gregg.0
Categories
- 36.6K All Categories
- 84 Hudson 1916 - 1929
- 18 Upcoming Events
- 73 Essex Super 6
- 28.3K HUDSON
- 507 "How To" - Skills, mechanical and other wise
- 989 Street Rods
- 150 American Motors
- 170 The Flathead Forum
- 47 Manuals, etc,.
- 68 Hudson 8
- 40 FORUM - Instructions and Tips on using the forum
- 2.7K CLASSIFIEDS
- 592 Vehicles
- 2.1K Parts & Pieces
- 76 Literature & Memorabilia
- Hudson 1916 - 1929 Yahoo Groups Archived Photos