Re: [HSS] Alemite "Pin Fitting" Grease Gun Quest

Unknown

TOM, did you ever get the greez gun/

LEW



In a message dated Mon, 5 Jun 2000 3:59:01 PM Eastern Daylight Time, "Tom Goodman" <tgood70779@aol.com> writes:



<< I actually did something constructive: Called my local Alemite

distributor and ordered P/N VB-942 end for my grease gun. It is a

replacement for the normal 'zerk' end on the business end of a grease

gun and fits the old "pin fittings". Cost is yet to be determined

but a 1992 catalog listed it at around $27. Two week delivery time

from the Alemite factory. An obvious use would be either to put it

on the end of the grease gun pipe or hose OR to screw a zerk fitting

into it (1/8 NPT threads, female) and make the elusive "adapter".

The VB-942 has "wings" (no comments please) that make turning it to

secure it to the stationary pin fitting a bit easier but it comes

either with or without (I ordered one of each and forgot the part

number of the "non-wing" model but I THINK it was 504511). We shall

see....



Greezy Hudsonly,



Tom





------------------------------------------------------------------------

Would you like to save big on your phone bill -- and keep on saving

more each month? Join beMANY! Our huge buying group gives you Long Distance

rates which fall monthly, plus an extra $60 in FREE calls!

http://click.egroups.com/1/2567/4/_/695705/_/960235072/

------------------------------------------------------------------------



Community email addresses:

Post message: HudsonSuperSix16-29@onelist.com

Subscribe: HudsonSuperSix16-29-subscribe@onelist.com

Unsubscribe: HudsonSuperSix16-29-unsubscribe@onelist.com

List owner: HudsonSuperSix16-29-owner@onelist.com



Shortcut URL to this page:

http://www.onelist.com/community/HudsonSuperSix16-29

>>