Cleaning up a few things on the 37 Hudson

BigSky

As I did some final preparations for the high compression heads installation, I had to address a couple things first.  Since I’m not using the heater & have no plans to use it, I was looking for a different plug for the top of the head, one to clean it up.  Below is a pic of what was present in the old head.  

After a little searching I found a nice 304 stainless steel plug with a recessed allen head.  With a bit of work I was able to get it recessed  nicely.  

Naturally, I wasn’t about to let this horrible thing back in my blocks drain hole.  

So there too I found a matching 304 stainless steel plug with a recessed allen head.  Here too I was able to get it recessed nicely.  

Hans

Nice ideas